1. LAYOUT AT SITE

Spread drop cloths and layout canopy at exact position of desired finished assembly. Any sharp objects which must remain on site under the canopy should be padded and taped.

Assemble side poles and lay straight out from each pole hole in canopy. Drive a stake 1' from the end of each pole. The stake must be driven through the rig attached to each guy rope as shown.

2. RAISE SIDE POLES

Start at opposite corners.

Insert side poles into pole holes and raise so that bottom of poles slant toward center of canopy.

Adjust guy rope.

3. RAISE CENTER POLE

Assemble three piece center pole and insert into center pole hole.

4. SIDE POLE ADJUSTMENT

Tighten guy ropes and then set side poles to upright position.

Adjust pole positions and guy rope tension to properly pull out canopy.